Filter
Top Products
5700/5800 GPS Receiver User Guide 119
General Operation 14
5800 GPS Receiver Operation
Table 14.2 shows approximate storage requirements for different
logging rates. The values shown are for a one-hour logging session with
six satellites visible.
144.2 Logging to a Trimble controller
When the 5800 receiver is connected to a Trimble controller, you can
log GPS data from the receiver to the controller, or to a PC card inserted
in the controller. When you use a Trimble controller, you do not use the
receiver’s controls. Instead, you use the controller functions to set
logging options, specify filenames, and control when logging occurs.
Data is stored in job files, which can be transferred to your office
computer using Trimble’s Data Transfer utility.
For more information on logging data from a receiver using a Trimble
controller refer to the user guide for your particular controller.
14.5Resetting to Defaults
To reset the 5800 receiver to its factory default settings, hold down [P]
for at least 15 seconds.
For more information, see Chapter 18, Default Settings.
Table 14.2 Storage requirements
Logging rate Memory required
10 Hz 2,588 KB
1Hz 335 KB
5 seconds 87 KB
15 seconds 37 KB