Filter
Top Products
6 Software Utilities
70 5700 GPS Receiver User Guide
Operation
To transfer the application file to the receiver:
1. Connect the data/power cable (Part Number 32345) to Port 1 on
the 5700 receiver.
2. Connect the female DB9 connector on the other end of the
data/power cable to a serial (COM) port on the computer.
3. Select File / Open to open the desired application file.
4. With the file open and the Configuration File dialog open,
select Communications / Transmit File.
A message appears informing you that the application file has
been successfully transferred. If an error occurs, select
Communications / Transmit File again. This overrides any
incompatibility in baud rates and enables successful
communication.
5. To check whether the transfer was successful, close the
Configuration File dialog and select Communications / Get
File.
A list of all application files in the 5700 receiver appears. If you
selected
Apply Immediately in the application file, the Current
application file will contain the settings in the new file.
6. To apply a different file, select the file you require from the list
and then select Communications / Activate File.