Filter
Top Products
5700 GPS Receiver User Guide 21
SettinguptheReceiver 2
Operation
If the clip lock is too tight to be locked, turn it one or two
turns counterclockwise and try again. If it is too loose, turn
it one or two turns clockwise and try to lock it again.
2. Mount the 5700 receiver on the bracket:
a. Pull the bracket side locks in towards the pole.
b. Set the receiver catch lock in the bracket.
c. Holding the receiver in the bracket, pull the side locks back
to their original positions.
Figure 2.9 5700 receiver bracket
3. Connect the blue TNC radio communications cable to the blue
TNC port on the receiver. Make sure that there is very little
slack in the cable. If necessary, adjust the position of the
receiver to remove slack.
4. Connect the yellow TNC GPS antenna cable to the yellow TNC
port on the receiver. Make sure that there is very little slack in
the cable. If necessary, adjust the position of the receiver to
remove slack.
Clip lock
Gates
Side locks