Filter
Top Products
2 SettinguptheReceiver
28 5700 GPS Receiver User Guide
Operation
Internal Radio Setup
You can configure the 5700 receiver’s optional internal radio using
any of the following:
• the GPS Configurator™ software
• the WinFLASH™ software
• the Trimble Survey Controller software
For more information, refer to the GPS Configurator Help, the
WinFLASH Help, or the Trimble Survey Controller Reference
Manual.
By default, the internal radio has only a few frequencies installed. Use
the WinFLASH software to configure additional frequencies. For
more information, see Adding Frequencies for the Internal Radio,
page 74.
External Radio Setup
To use an external radio with the 5700 receiver, you need an external
power source for the radio.
To set up a 5700 receiver using an external radio:
1. Connect one end of the yellow GPS antenna cable to the yellow
TNC port on the 5700 receiver.
2. Connect the other end of the GPS antenna cable to a Zephyr or
Zephyr Geodetic antenna.
3. Connect the external radio to Port 3 on the receiver.
4. Connect a radio antenna to the external radio.