Filter
Top Products
5700 GPS Receiver User Guide 115
Default Settings 10
Reference
10.4.3 Logging after Power Loss
If the 5700 loses power unexpectedly, when power is restored the
receiver tries to return to the state it was in immediately before the
power loss. The receiver does not reset itself to defaults or apply any
Power Up settings. If the receiver was logging when power was lost
unexpectedly, it resumes logging when power is restored.
However, when you switch the 5700 receiver off using
,the
receiver behaves as if you pressed
to stop logging before you
pressed . In this case, when power is restored normally, logging
does not begin until you start it manually.
10.4.4 Disabling Logging
You can disable logging by setting the receiver’s data logging and
position logging rates to Off. However, if you press
while logging
is disabled, the receiver will still log data, using the default logging
settings.
When the receiver is logging
data and then loses power …
thenwhenpower
is restored, data
logging …
and logging
settings are …
and all other
settings are …
unexpectedly resumes
automatically
the last settings
used
the last settings
used
when you press
does not resume the factory
defaults
the last settings
used
When you have disabled logging … then if you press to start logging,
logging settings are …
using the Trimble Survey Controller or GPS
Configurator software
the factory defaults
in the Power Up application file the factory defaults