Filter
Top Products
98
6 F 8 A 0 9 3 4
8.2.27 LCD Adjustment
This section describes how to set the LCD density adjustment value for the converter display.
The LCD density can be set in 5 levels.
LCD density adjustment level 1 2 3 4 5
LCD density Light Dark
The LCD density adjustment value is set to "3" when shipped from the factory.
The display of the LCD gradually becomes thinner over time.
If the display is getting difficult to read, you need to adjust the density level using this parameter.
The following is an example to change the LCD density adjustment level from 3 to 5 DARK.
Switch operation
Display example
Description
Select "LCD ADJ" from the setting item
selection menu.
The current setting (3 in this example)
appears.
Then push .
* Pushing returns you to the menu
screen.
The switches at the bottom change.
( are shown.)
At the same time, the cursor appears.
(The item indicated by the cursor is
highlighted.)
Then push .
You can continue to change the setting item.
Push to change the selection
items.
: Selected item is scrolled up.
: Selected item is scrolled down.
When the desired item is selected, push
to set the item temporarily.
When you push , a message appears
to confirm whether the setting is OK or not.
If OK, push . If you want to redo the
setting, push .
Pushing cancels the setting operation
and exits the setting screen.