Filter
Top Products
31
6 F 8 A 0 9 3 4
5.4.2 Cable Connection
Connect and install the terminal-treated cables to the terminal block by the following procedure.
Connect the cables to the terminal block securely. A loose connection may cause incorrect
measurement. After connecting a cable, try to pull it to check whether it has been connected
securely.
Referring to Section 5.2 "External Device Connections and Grounding", connect each cable to the
terminal block. Tighten the screws of the terminal block tightly to ensure the secure connection. A
loose connection may cause incorrect measurement. After connecting a cable, try to pull it to see
whether it has been connected securely.
Figure 5.10 Connecting a Cable to Terminal Block
Phillips screwdriver
Terminal block
The appropriate torque for tightening
the terminal board screw is 1.2 N•m.