Filter
Top Products
89
6 F 8 A 0 9 3 4
8.2.22 Preset Mode
The preset mode determines the function when the totalizer reaches the preset count.
The present mode can be set from the items shown below.
●Preset mode
Selection items Preset mode
HOLD Holds the output value.
50ms PLS Outputs a one shot pulse of 50ms width.
500ms PLS Outputs a one shot pulse of 500ms width.
Note: If you set the preset mode to "50ms PLS" or "500ms PLS", you need to set the preset
count to 1, 2, 5, 25, 125 ×10
n
. (If you set a value that does not meet this condition, the
preset output timing may be shifted when the totalizer overflows.
You can check or change the preset mode as described below.
The following is an example to change the present mode from Output condition hold (HOLD)
to One-shot pulse output with pulse width of 50ms (50ms PLS).
Switch operation
Display example
Description
Select "OUT MODE" from the setting item
selection menu.
The current setting (HOLD in this example)
appears.
Then push .
* Pushing returns you to the menu
screen.