Filter
Top Products
100
6 F 8 A 0 9 3 4
The following is an example to change the switch position setting from BOTTOM to TOP.
Switch operation
Display example
Description
Select "SW POSN" from the setting item
selection menu.
The current setting (BOTTOM in this
example) appears.
Then push .
* Pushing returns you to the menu
screen.
The switches at the bottom change.
( are shown.)
At the same time, the cursor appears.
(The item indicated by the cursor is
highlighted.)
Then push .
You can continue to change the setting item.
Push to change the selection
items.
: Selected item is scrolled up.
: Selected item is scrolled down.
When the desired item is selected, push
to set the item temporarily.
When you push , a message appears
to confirm whether the setting is OK or not.
If OK, push . If you want to redo the
setting, push .
Pushing cancels the setting operation
and exits the setting screen.
8.2.29 Communication Setting
This setting is needed when optional PROFIBUS communication board is installed.
For details, refer to the instruction manual of PROFIBUS communication board.
If communication board is not used, this address setting is not needed.