Filter
Top Products
75
6 F 8 A 0 9 3 4
8.2.13 Display Low Cutoff
When low cutoff is set in 8.2.12 “Low Cutoff,” this function determines whether to use the low cutoff
processing for displayed values.
You can select the display low cutoff setting from the items in the table below.
● Display low cutoff setting function
Selection items Displayed values
LINEAR
Low cutoff processing is not used for displayed
values.
LOW CUT Displayed values are processed with low cutoff.
For example, if the low cutoff is set to 10% and the indicated value of the input from the detector is
5%, the displayed value on the screen becomes as shown below.
Display low cutoff Displayed value
LINEAR 5.0%
LOW CUT 0.0%
You can check or change the display low cutoff as described below.
The following is an example to change the setting from LINEAR to LOW CUT.
Switch operation
Display example
Description
Select "DSPL SET" from the setting item
selection menu.
The currently set low cutoff setting
(LINEAR in this example) appears.
Then push .
Pushing returns you to the setting
menu.
The switches at the bottom change.
( are shown.)
At the same time, the cursor appears.
(The item indicated by the cursor is
highlighted.)
Then push .
You can continue to change the setting item.
Push to change the selection
items.
: Selected item is scrolled up.
: Selected item is scrolled down.
When the desired item is selected, push
to set the item temporarily.