Filter
Top Products
48
6 F 8 A 0 9 3 4
Switch operation Display example Description
Push to select the item you want
to check or change.
The screen changes and the currently set
item appears for you to check.
Pushing returns you to the menu
screen.
When you push , the cursor appears
on the setting value and the screen is ready
to change the setting value.
Ready to change the setting value
Pushing increments the number in
the place where the cursor is positioned.
(Holding down the switch longer causes the
operation to continue.)
* Pushing when the cursor is positioned
below the digit of unit will change the unit to the
next unit. In addition, if a natural number is used, a
decimal point as well as the numeric value appears.
Ready to change the setting value
Pushing moves the cursor to the
next digit.
Ready to change the setting value
Change the setting value using and
.
In this example, 5.000 m/s is set.
Pushing sets the data temporarily.
The cursor disappears and a message
appears to confirm whether it is OK or not.
If you want to cancel the operation, for
example, because the temporarily set data is
incorrect, pushing returns the
temporarily set data to the previous value,
enabling you to change the setting value
again.
Pushing cancels the setting operation
and exits the setting screen.