Filter
Top Products
86
6 F 8 A 0 9 3 4
You can check or change the count rate and pulse width as described below.
The following is an example to change the count rate from 0.01m
3
to 0.9 L.
Switch operation
Display example
Description
The currently set count rate (0.01m
3
in this
example) appears.
Then push .
The switches at the bottom change.
( are shown.)
At the same time, the cursor appears.
Push to move the cursor to the digit
of the unit and push to change from
“m
3
” to “L”.
Push to move the cursor to the digit
you want to change and push to
change the number of the digit.
When you push , a message appears
to confirm whether the setting is OK or not.
If OK, push . If you want to redo the
setting, push .
Pushing cancels the setting operation
and exits the setting screen.
To set the pulse width setting mode or pulse width, select the relevant item below from the setting
menu.
Pulse width setting mode PLS MODE
Pulse width PLS WID