Filter
Top Products
62
6 F 8 A 0 9 3 4
For example, if the setting range is 10m/s and display digit setting is 1/100, the measured value will
be displayed to the first decimal place.
Likewise, when the setting range 1m/s and display digit setting is 1/100, the measured value will be
displayed to the second decimal place.
The numbers less than the displayed digits will be rounded.
Note: The maximum display digits for flow velocity, flow rate and custom value are 7 digits.
If the measured value exceeds 7 digits, the displayed value remains fixed at the maximum display
value.
● Changing the totalized flow volume direction
You can change the totalized flow volume direction as described below.
The following is an example to change the Display 1 setting from Fixed forward totalized flow (F)
to Bidirectional flow (B).
Switch operation
Display example
Description
Select "DSPL1" from the setting item
selection menu.
The currently set display setting (m
3
F in
this example) appears.
Then push .
The switches at the bottom change.
( are shown.)
At the same time, the cursor appears.
Push to move the cursor to the
third unit (totalized flow direction) and then
push to change the direction.
Then push to set the display unit
temporarily.
Pushing shows a message to confirm
whether the setting is OK or not.
If OK, push . If you need to redo the
setting, push .
Pushing cancel the setting operation
and exits the setting screen.
Maximum effective digits
One hundredth of
maximum effective digits