Raymarine 631 PLUS GPS Receiver User Manual


 
4-6 SL520/530/631 PLUS Chartplotter Displays
Man Overboard
(MOB)
4.4 Man Overboard (MOB)
If you losea personor object overboard, and need toreturn to the location, you
should use the Man Overboard (MOB) function.
You can select the type of data used for the MOB position using the set up
menus (see Section 5.3).
Note: To obtain MOB position, you need either of the following:
Position data from a GPS or equivalent device
Heading and speed data, so that the position can be calculated by dead
reckoning
To initiate the MOB procedure, press and hold the MARKS key for two
seconds. The system then performs the following tasks automatically:
Redrawsthe chartat 1/2nm (even ifcartographyis notavailablebut plotter
mode is on).
Marks the current position with a MOB symbol which replaces any
current active waypoint and route.
Displays the MOB data box, showing the bearing and distance from your
vessel to the MOBwaypoint position, and the elapsed time since theMOB
was initiated (Figure 4-3).
Displays the position data box, showing your vessels position.
As your vessel moves from the MOB position, a dotted line is displayed
connecting the MOB symbol and the vessels current position.
Sounds a 4-second alarm pattern every 30 seconds.
Sends an MOB message (including bearing and distance) to other units in
the system, via the SeaTalk connection.
Figure 4-3: MOB Display
MARKS
D4273-2
RNG
0.33
nm
BRG
162°
T
00:05:24
MOB
MOB data box
MOB position
POSITION
N 49°54^76
W 002°09^83