Filter
Top Products
5-2 SL520/530/631 PLUS Chartplotter Displays
Changing the Set Up
Parameters
5.2 Changing the Set Up Parameters
The set up parameters are divided into two sections:
• System, to control the aspects of the system that are not specific to the
chart.
• Chart,to controlthe chartplotter display ,includingwaypoint information
and vectors.
Note: The GPS and Track Set Up menus are described in Chapter 4.
This section provides instructions for displaying and changing the default
values. The following sections list the parameters and their possible settings,
and describe the function of each parameter in turn.
➤ To set the default parameters:
1. Press the MENU key to display the set up soft keys - the options available
depend on the selected operating mode.
2. Press the soft key for the set up you require.
The requested set up menu is displayed, listing the parameters and their
current settings.
3. Use the trackpad to move the selection bar up and down the list. An arrow
is displayed at the top or bottom right-hand corner if you can scroll the list
to display further parameters.
As each line is highlighted, the soft keys are updated to show the settings
available.
• For parameters that have a numeric value, or more than four possible
settings, a scroll list is displayed above two of the soft keys.
• Some parameters are controlled by a slider that is displayed above two
of the soft keys.
• For some parameters, a soft key provides access to a sub-menu of fur-
ther options.
4. Pressthe soft keycorrespondingtothe desiredsettingor,forscroll lists,use
the soft keys to scroll forwards or backwards through the list until the
required setting is displayed. This setting is retained when you move the
selection bar on to the next parameter in the menu list.
For sliders, press the appropriate soft key repeatedly to increase or
decrease the slider value in individual steps, or press and hold the key to
change the setting quickly.
MENU
D4162-1
SYSTEM
SET UP¬
CHART
SET UP¬
TRACK
SET UP¬
GPS
SETUP¬