Filter
Top Products
Chapter 6: Installation 6-15
System Checks and
Inital Switch On
6.7 System Checks and Inital Switch On
Once you have installed your Chartplotter and made all the connections, you
need to check your installation and perform the System Checks before using
the system for navigation. It is strongly recommended that the System Checks
are performed before connecting the display to other equipment in an
integrated system. If you encounter any problems, refer to Chapter 7.
You may wish to read Chapters 2 to 4, and familiarise yourself with the
operation of the system, before performing the initial set up and alignment.
System Check
Before performing the functional test, check the following:
• All securing bolts are fully tightened and mechanical locking arrange-
ments as specified are in place.
• All connections have been made.
• All connecting wires are secured and protected as necessary.
Note: If you are the boat owner and have performed the installation yourself,
ask your authorised installation dealer to check the installation before going
to sea.
Switch On and Initial Setup
To switch on the display unit, press and hold the POWER key until the unit
beeps.
If necessary, adjust the lighting (see Changing the Lighting & Contrast -
SL520 Mono Display on page 2-4 or Changing the Brightness - SL530/631
Color Display on page 2-5).
If required, change the default language settings as follows:
1. Press the MENU key to display the setup soft keys.
2. Press the SYSTEM SET UP soft key.
The SYSTEM SET UP menu is displayed, listing the parameters and their cur-
rent settings. The complete list,which you can scroll down,is shown in the
following illustration.
D4162-1
SYSTEM
SET UP¬
CHART
SET UP¬
TRACK
SET UP¬
GPS
SETUP¬