Filter
Top Products
2-2 SL520/530/631 PLUS Chartplotter Displays
Switching the Display
On and Off
2.2 Switching the Display On and Off
➤ To switch the display on, press and hold the POWER key until the unit beeps.
If the display was last used in chartplotter mode, the keys light up and the
Raychart graphic is displayed, followed by the caution:
CAUTION:
Raychart chart displays are based on cartographic data that
C-MAP believes to be accurate. However, you should not rely on these
displays as your primary source of navigation. Rather, your Raychart
should be used only as a backup to official government charts and
traditional methods of navigation.
When you have readand understood the caution,press the CONTINUE soft key.
The chart is displayed.
If this is the first time the chartplotter has been turned on, and no chart card is
installed, the display shows the small-scale world map and the default soft
keys. Otherwise, the display shows the selected chart area and any data that
were displayed when the display was last used.
Figure 2-1: Switch On - Chart Mode
Switch Off
CAUTION:
To provide protection against the damaging effects of UV light, it is
advisableto replace thesuncover providedwhen thecolor LCDdisplayis
not in use.
A reminder is displayed when you switch off the color LCD display.
D4277-2
Until unit beeps