Filter
Top Products
User’s manual NAVIGON 92 Plus | 92 Premium
Navigation - 27 -
The integrated GPS receiver is not initialised for the first time until the
navigation application is started for the first time. It can take up to
20 m
inutes to initialise the GPS receiver for the first time.
Eac
h time you switch on the navigation device after this, GPS reception
will start within a short time.
If the navigation device has not been switched on for more than a week,
it can take up to 10 minutes to re-initialise the receiver.
Note: Directly after the GPS symbol indicates the GPS Ready state,
the accuracy of the positioning may be reduced for a few minutes.
In the top right hand corner of the screen you will see the GPS symbol.
As soon as data from at least three satellites is received, the symbol will
change to (GPS Ready).
Note: Initialisation takes the least time if you do not start driving until
the initialisation has finished.
For more details about the GPS symbol refer to chapter "GPS" on
page 18.
Returning to the Navigation window
The NAVIGATION window opens when the navigation application is
started.
If a window with a visible button bar is opened:
► In the bar tap on (Navigation).
If the map is open in Standard mode or in Vehicle mode:
► Call up the button bar (see "Button bar" on page 58).
► In the bar tap on (Navigation).
If a different window of the navigation application is open:
► Tap on (Back). This will return you to the window you
came from.
► Tap on (Back) repeatedly until the NAVIGATION window is
opened.
7.2 Specifying a destination
You can either enter a new destination or select a saved destination.
To enter a new destination you can
► enter the address of the destination (see "Enter an Address" on
page 28).