Filter
Top Products
You cannot position your vehicle
on themap without a significant
positioning error.
The navigation systemmay not be
mounted securely inyour vehicle.
Check thatthe navigation system issecurely
mounted and, ifnecessary, consultthe dealer
that installed thesystem.
The navigation systemis installed
with anextreme angle exceeding
the installation anglelimitations.
Confirm the installation angle. (Thenaviga-
tion system mustbe installed withinthe al-
lowed installation angle.For details,refer to
“Installation Manual”.)
Indication of theposition of your ve-
hicle ismisaligned after a U-turnor
reversing.
Check whether ornot the reversegear signal
input lead(violet) is connected properly.(The
navigation system worksproperly without the
lead connected, butpositioning accuracy will
be adversely affected.)
The mapcolor does not switch
automatically between daytime
and nighttime.
[Night mode] isset to [Day]. Check [Night mode] settingand make sure
[Automatic] is selected. (Page146)
The orange/white leadis not con-
nected.
Check the connection.
The screen istoo bright. An improper value hasbeen set on
“Brightness”.
Check the settings.
The display isvery dim. [Night] isselected in “Night
mode”.
Check the settingof [Night mode] andselect
[Automatic]or[Day]. (Page146)
An improper value hasbeen set on
“Brightness”.
Check the settings.
No sounds ofAV sourceare pro-
duced.
The volume levelwill not rise.
The volume levelis low. Adjust thevolume level.
The attenuator ormute is on. Turnthe attenuator or muteoff.
A speaker leadis disconnected. Checkthe connection.
The volume ofnavigation gui-
dance and beepscannot be ad-
justed.
Try toadjust them withMULTI-CON-
TROL.
Turnthe volume up ordown using [Sound
settings]onthe“Navi Settings”menu.
(Page 150)
The person onthe other endof
the phonecall cannot hear the
conversation due toan echo.
The voice fromthe person onthe
other end ofthe phone callis output
from thespeakers andthen picked
up bythe microphone again, creat-
ing an echo.
Use the followingmethods to reducethe
echo:
—Lower the volumeon the receiver
—Have bothparties pause slightly before
speaking
There’s no picture. The parking brakecord is notcon-
nected.
Connect the parkingbrake cord, andapply
the parking brake.
The parkingbrake is not applied. Connect the parkingbrake cord, andapply
the parking brake.
The backlight ofthe LCD panelis
turned off.
Turnon the backlight. (Page 160)
“Rear display” picturedisap-
pears. (This information isin-
tended forAVIC-X9115BTonly.)
The source discbeing listened toin
the navigation systemhas been
ejected.
Before ejecting thedisc, switch thesource.
This problem mayoccur when certain con-
nection methods areused.
There isa problem with the“Rear
display”, for examplea faulty wiring
connection.
Check the “Rear display” andits connection.
An AV sourcethat cannot output to
the reardisplay isselected.
Select an appropriateAV source.
Appendix
En
179
Appendix
Appendix