Filter
Top Products
p Once you start the cataloging process, only
a few basic voice commands can be used
for iPod until the process has completely
finished.
p If unreadable characters are included in
the data on your iPod, names or types may
not be available as voice commands.
Important Notice regarding Voice
Control for iPods
Voice Control for iPods may be limited if cata-
loging of iPod content is not completed. Cata-
loging of iPod content only occurs when the
system is in “AV Source” mode and the “iPod”
is the selected and displayed “AV Source”
screen. Cataloging of iPod content will not
occur if the system is off, if any other “AV
Source” is selected (aside from iPod), or if the
system is in any other mode (aside from “AV
Source” mode) such as “Destination Menu”,
“Contacts”, “Settings Menu”, “Phone Menu”
or the map screen. If you wish to use Voice
Control for all iPod content, it is recommended
that you first connect your iPod, select “iPod”
as the AV source, and keep the iPod screen
displayed until cataloging is completed — cat-
aloging of iPod content should only take a few
minutes, and will depend on the size of the
content stored on your iPod. A message will
be displayed when cataloging is completed.
1 Touch [VR Catalog Mode] on the “AV
System Settings” menu.
= For details, refer to Displaying the “AV Sys-
tem Settings” menu on page 164.
2 Touch [On] or [Off] to activate or deacti-
vate “VR Catalog Mode”.
Customizing preferences
En
167
Chapter
25
Customizing preferences