Filter
Top Products
3 Turn the ignition switch to ON or ACC.
If the car’s air conditioner or heater is turned
on, turn it off. Noise from the fan in the air
conditioner or heater may prevent correct auto
TA and EQ.
4 Press SOURCE to turn the source off if
this unit is tur ned on.
5 Touch the screen to display the touch
panel keys.
6 Touch AV MENU and then touch
AUTO EQ&TA to enter the auto TA and EQ
measurement mode.
7 Touch either of the following touch
panel keys to select the position for the
seat on which the microphone is placed.
! FRONT LEFT – Front seatleft
! FRONT RIGHT – Front seatright
8 Touch NEXT.
9 Plug the AUTO TA&EQ microphone into
the microphone/auxiliary input jack on this
unit.
AUTO TA&EQmicrophone
10 Touch START to start the auto TA and
EQ.
11 Get out of the car and close the door
within 10 seconds when the 10-second
count-down starts.
The measurement tone (noise) is outputted
from the speakers, and auto TA and EQ be-
gins.
# When all speakers are connected, auto TA
and EQ is completedin about 14 minutes.
# To stopauto TA and EQ, touch STOP.
# To cancelauto TA and EQ part way through,
touch BACK or ESC.
12 When auto TA and EQ is completed,
Complete is displayed.
When correct measurement of car interior
acoustic characteristics is not possible, an
error message is displayed. (Refer to Under-
standing auto TA and EQ error messages on
page 113.)
13 Touch ESC to cancel the auto TA and EQ
mode.
14 Store the microphone carefully in the
glove compartment.
Store the microphone carefully in the glove
compartment or any other safe place. If the
microphone is subjected to direct sunlight for
an extended period, high temperatures may
cause distortion, color change or mal-
function.
Audio Adjustments
En
94
Section
17