Filter
Top Products
2 Press RESET with a pen tip or other
pointed instrument.
RESET button
Note
After completing connectionsor when youwant
to erase all memorizedsettings or return the unit
to its initial (factory) settings, switchyour engine
ON or set theignition switch to ACC ON before
pressing RESET.
Feature demo mode
The feature demo automatically starts when
you select the source OFF. The demo con-
tinues while the ignition switch is set to ACC
or ON. To cancel the feature demo, press and
hold SOUND SETTING. To restart the feature
demo, press and hold SOUND SETTING
again. Remember that if the feature demo
continues operating when the car engine is
turned off, it may drain battery power.
Important
The red lead (ACC)of this unit should be con-
nected to a terminalcoupled with ignition switch
on/off operations. If thisis not done, the vehicle
battery may be drained.
Use and care of the remote
control
Installing the battery
Slide the tray out on the back of the remote
control and insert the battery with the plus (+)
and minus (–) poles pointing in the proper di-
rection.
! When using for the first time, pull out the
film protruding from the tray.
WARNING
Keep the battery out of the reachof children.
Should the battery be swallowed,immediately
consult a doctor.
CAUTION
! Use only one CR2025(3 V) lithium battery.
! Remove the battery if the remotecontrol is not
used for a monthor longer.
! Do not recharge, disassemble, heat or dispose
of the battery in fire.
! Do not handle thebattery with metallic tools.
! Do not store thebattery with metallic materi-
als.
! In the event ofbattery leakage, wipe the re-
mote control completelyclean and install a
new battery.
! When disposing ofused batteries, please
comply with governmental regulations or en-
vironmental public institutions’ rules that
apply in your country/area.
Using the remote control
Point the remote control in the direction of the
front panel to operate.
Before You Start
En
13
Section
02
Before You Start