Filter
Top Products
Adjusting the volume
% Use VOLUME to adjust the sound level.
With the head unit, rotate VOLUME to in-
crease or decrease the volume.
With the remote control, press VOLUME to in-
crease or decrease the volume.
Turning the unit off
% When using the touch panel keys,
touch the source icon and then touch OFF.
# When the source iconis not displayed, you
can display it bytouching the screen.
% When using the button, press SOURCE
and hold until the unit turns off.
Using the rear display
You can watch the video sources (such as
DVD or AV) on rear display independently of
front display.
! To watch a DVD/Video CD on the rear dis-
play only, switch the operation mode on the
remote control to DVD. And you can oper-
ate the DVD/Video CD playback on the rear
display independently by the remote con-
trol. (Refer to page 19.)
CAUTION
When you have turnedthe rear display output on
by pressing REAR ON, you cannotturn it off even
if you press SOURCE andhold. In this case, press
REAR ON and holdto turn the rear display output
off.
% Press REAR ON to select the video
source on the rear display.
Press REAR ON repeatedly to switch between
the following video sources:
F. SOURCE (same source as the front display)
—DVD (built-in DVD player)—AV1 (AV 1
input)—AV2 (AV 2 input)
Rear display output is turned on and the illu-
mination color of REAR ON changes to a dif-
ferent color from the other buttons.
# You can also perform this operationby press-
ing REAR SOURCE onthe remote control.
# To turnthe rear display output off, press
REAR ON and hold.
# When selecting F. SOURCE, when theselected
source is an audiosource, nothing is displayed
on rear display.
# When you watch DVD(built-in DVD player) on
both the front andthe rear display, audio is not
outputted from REAR DISPLAY OUT.
# When selecting FRONTin REAR MODE, you
can select F. SOURCEonly. And audiois not out-
putted from REAR DISPLAY OUT. (Refer to Set-
ting the video ofrear display on page 97.)
Note
In the following cases,the sound source will not
change:
! When there is nodisc in the unit.
! When the AV (AV input)is not set to VIDEO
(refer to page 95).
Basic Operations
En
22
Section
04