Filter
Top Products
Introduction to built-in DSP
features
Important
We recommend that you recordthe settings in
the sheet on page121 after youhave completed
audio adjustments.
DSP modes
This unit features two DSP modes: the net-
work mode and the standard mode. You can
switch between DSP modes as desired. Initi-
ally, the DSP mode is set to the standard
mode. (Refer to Switching the DSP setting
mode on page 104.)
! Auto TA and EQ can be used for the stan-
dard mode only. (Refer to Auto TA and EQ
(auto-time alignment and auto-equalizing)
on page 92 and Using the auto-equalizer on
page 91.)
! A 2-way front speaker output can be used
for the network mode only.
Note
Switching the DSP modeerases the current ad-
justing audio settings (LAST MEMORY). If
needed, memorize it into custom settings
(CUSTOM1, CUSTOM2 or CUSTOM3).
Output channel modes
(2CH/Multi CH)
This unit has two output channel modes for
each DSP mode: the 2-channel mode and the
multi-channel mode. You can switch between
output channel modes depending on the
source that you have selected.
! Dolby Pro Logic II/EX and DTS Neo:6
(Dolby/DTS) can be used for multi-channel
mode only.
! Graphic equalizer (GRAPHIC EQ) can be
used for 2-channel mode only.
! Parametric equalizer (PARAMETRIC EQ)
can be used for multi-channel mode only.
Note
When selecting 2-channelmode, audio does not
be output from frontcenter and rear center
speakers.
Sound settings (SETTING1,
SETTING2 or SETTING3)
Created acoustic sound field can be stored in
this unit and called up easily. Additionally, this
unit stores the sound setting and output chan-
nel information for each source group. Chan-
ging the source switches sound setting and
output channel information for each source
group at the same time.
Three types of sound settings can be set and
stored for both 2-channel mode and multi-
channel mode independently. Moreover,
sound settings can be stored for both the net-
work mode and the standard mode. Therefore,
a total of 12 types of sound settings can be set
and stored.
! Auto TA and EQ can be performed only
when the standard mode is selected. Per-
forming Auto TA and EQ creates auto set-
tings (AUTO) which are adjusted finely for
both 2-channel mode and multi-channel
mode. However, AUTO cannot be custo-
mized.
Source groups
Each source stores both sound settings and
output channels information. When a DVD
player (built-in or optional) is selected as a
source, the each medium stores these settings
independently.
Media of DVD player are listed as follows:
! DVD audio (AOB: audio object)
Audio Adjustments
En
76
Section
17