Filter
Top Products
For viewing LCD comfortably
Due to its construction, the viewing angle of
the LCD screen is limited. You can adjust it by
changing either screen size or picture adjust-
ment.
Changing the wide screen size
By changing the screen size from 4:3 to 16:9,
you can adjust the screen so that the screen
can fit to the video image you are playing.
For details concerning operation, refer to
Changing the wide screen mode on page 106.
Changing the picture adjustment
You can make the best adjustment to the pic-
ture display by changing BRIGHT, CONTRAST,
COLOR and HUE. You can also dim or enlight
the overall picture image using DIMMER.
For details concerning operation, refer to
Changing the picture adjustment on page
106.
What the marks on DVDs
indicate
The marks below may be found on DVD disc
labels and packages. They indicate the type of
images and audio recorded on the disc, and
the functions you can use.
Mark Meaning
2
Indicates thenumber ofaudio sys-
tems.
2
Indicates thenumber ofsubtitle lan-
guages.
3
Indicates thenumber ofviewing an-
gles.
Mark Meaning
16 : 9 LB
Indicates thepicture size(aspect ratio:
screen width-to-heightratio) type.
2
3
4
ALL
Indicates thenumber ofthe region
where playbackis possible.
When an operation is prohibited
When you are watching a DVD and attempt to
perform an operation, it may not be performed
because of the programming on the disc.
When this happens, the icon
appears on
the screen.
! The icon
may not appear with certain
discs.
Resetting the microprocessor
Pressing RESET lets you reset the micropro-
cessor to its initial settings without changing
the bookmark information.
The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
Important
If you press RESET, all memorized settingsare
erased. For this reason, we recommend that you
record the settings inthe sheet on page 121after
you have completedaudio adjustments.
1 Turn the ignition switch OFF.
Before You Start
En
12
Section
02