Filter
Top Products
3 Touch or to adjust the distance be-
tween each speaker and the listening posi-
tion.
Each time you touch
or it increases or de-
creases the distance. 0.0cm to 500.0cm is dis-
played as the distance is increased or
decreased.
# You can mute the selectedspeaker unit by
touching MUTE. To cancelmuting, touch MUTE
again.
# You cannot select speakerswhose size is set
at OFF.
Note
You can store the adjustedsetting in memory by
using MEMORY. For details concerningopera-
tion, refer toStoring the adjusted audio settings in
memory on the next page.
Adjusting the speaker
output levels
You can adjust the speaker output level of
each speaker unit.
Recalling the speaker output
level settings
% Touch SPEAKER LEVEL on the sound
setting menu to select the speaker output
level setting.
Touch SPEAKER LEVEL repeatedly to switch
between the following speaker output level set-
tings:
CUSTOM1—CUSTOM2—CUSTOM3—AUTO
—LAST MEMORY
# You can select LASTMEMORY only whenthe
adjusted speaker outputlevel setting is not mem-
orized in this unit.
# You cannot select AUTOwhen NETWORK
has been selected. (Refer to Switching theDSP
setting mode on page104.)
# When STANDARD hasbeen selected, you
cannot select AUTOif auto TA and EQ has not
been carried out.
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1 Recall the speaker output level settings
you want to adjust.
Refer to Recalling the speaker output level set-
tings on this page.
2 Touch ADJ. next to SPEAKER LEVEL on
the sound setting menu and then touch
TEST TONE.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
Front left speaker—Front center speaker—
Front right speaker—Rear right speaker—Rear
center speaker—Rear left speaker— Subwoo-
fer
Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the
test tone.
# Using TEST TONE, the tweeters andthe front
speakers are adjustedsame time. To adjustthem
separately, please refer to Adjustingthe speaker
output levels finely onthe next page.
# The settings do notappear for speakers
whose size is setOFF.
3 Touch or to adjust the speaker out-
put level.
Each time you touch
or it increases or de-
creases the speaker output level. –24dB to
+10dB is displayed as the level is increased or
decreased.
Audio Adjustments
En
90
Section
17