Filter
Top Products
8
Press the UP ARROW. Notice that
the highlighted number has
incremented by one. Keep pressing
the UP ARROW until the first digit
matches the first number you
found for latitude. If you go past
the number you want, you can use
the DOWN ARROW to step down
or continue using the UP ARROW
and loop through the number
sequence.
When the correct number is
displayed, press the RIGHT
ARROW to step to the second digit
on the latitude line.
What’s important to remember
here is that the UP/DOWN
ARROWs step up or down through
the numbers and the RIGHT/LEFT
ARROWs move the highlight to the
right or left.
Continue entering the latitude. Use
the RIGHT ARROW to highlight
the “N” at the end of the latitude
line. Latitude may be north “N” or
south “S” and may be changed, if
necessary, by using the UP/DOWN
ARROW. Once the latitude is
correct, press ENTER.
The cursor (highlighted area) has
now jumped down to the first char-
acter on the longitude line. Follow-
ing the same procedure as before,
enter the longitude and “E” or
“W”.
Your display should now resemble the one shown above with your latitude
and longitude. If all of the information for the latitude and longitude is cor-
rect, press ENTER. (If you notice now that you made a mistake in the latitude
or longitude, press MNU, highlight SETUP MENU and press ENTER. Select
INITIALIZE, press ENTER to start over.)
0`00.00N 0
COORDINATE
000`00.00W
0
COORDINATE
3 `00.00N
000`00.00W
W
COORDINATE
34`17.00N
118`39.00
N
COORDINATE
34`17.00
000`00.00W