Filter
Top Products
43
The Transfer My Data screens for both the Save and Load commands
are shown far left and far right. When you select Save Data in the far
left Transfer My Data screen, a keyboard will appear (center) allowing
you to enter a file name.
When you transfer GPS data files to the unit, the file will be added to
all the "normal" places where you would access that data. For example,
any routes in the GPS data file will be added to the Route Via Destina-
tions list. Any trials will be added to the My Trails list. Waypoints will
be added to the Address Book. All of these files should be visible from
the map screen.
GPS Simulator
The unit has a GPS Simulator allowing it to simulate the
navigation of a route. The simulator control buttons are
located in the bottom left of the map screen.
If you are in Simulator Mode while driving and reach a speed of about
15 miles per hour or greater, and the unit acquires a satellite lock, the
unit will leave Simulator Mode. If the unit does not have satellite lock
it will prompt you to simulate when you begin to navigate a route. If
the prompt is ignored for 20 seconds the unit will assume you do not
wish to simulate a route.
The red X on the GPS Simulator button (left) indicates the feature is
turned off. The unit simulating a route is shown at right. The simula-
tor control buttons are located in the bottom left corner of the map
screen.
Simulator
control
buttons
Drop down box
File name text box