Filter
Top Products
8. Turn the UPS power switch to OFF green light out
9. Turn Cockpit power OFF on A frame power strip.
The system is now secured.
2-11 Emergency Stop Procedures
In the event of an emergency follow the procedures described below for the type of emergency.
2-11A Occupant Panic Switch
During the ride the patrons have the ability to initiate a ride abort by depressing the
Occupant Panic Switch (Labeled “Safety Stop” in the cockpit). When this switch is
depressed the ride will return to the “home” position, the video projector will freeze and
the sound will stop. Once the unit is level, lower the unit by clicking the “lower” icon on
the computer screen. When the unit is completely lowered onto the stairway, open the
cockpit door and ask the riders if they would like to continue. If they do not which to
continue, discharge the passengers following the Passenger Unloading Procedure. If they
wish to continue, close the canopy and secure it with the locking device. Click on the
“raise” icon and once the unit is completely balanced it will raise to top and continue.
2-11B Emergency Termination Procedures
In the event of an emergency not involving the simulator directly, click on the ‘STOP” icon on the screen.
Wait for the unit to level, and then lower the platform as normal. In the event that the unit is not
responding to the commands, use the Red EMERGENCY STOP BUTTON on the side of the Command
Consol to terminate power to the electric motors. The unit will then have to be leveled and lowered
manually as described in section 2-11C. Assist the patrons out of the simulator and direct them to the exit.
2-11C Emergency Stop without Electrical Power
The Red EMERGENCY STOP BUTTON on the side of the Command Consol must be depressed
IMMEDIATELY; this will disable the Electric Motors and set the manual brakes. Level the unit on both
the pitch and roll axis manually as described in section 2-11C. Using the manual BRAKE RELEASE on
the back of the lift motor, slowly lower the unit to the base. Open the canopy and release the restraint
harness and assist patrons from the cockpit.
Fig. 1 Fig. 2
2-11D Emergency Leveling and
Lowering
To level the machine in the pitch axis pull on the
PITCH BREAK RELEASE (Fig. 1) and level the
machine manually. There is a level mounted on
the Roll Motor (Fig. 2) to aid in getting the ride
into the home position. A Second person should
be used when performing this procedure.
Fig. 3 Fig. 4
To level the machine in the roll axis
move the manual BREAK RELEASE
LEVER (Fig. 3) towards the Tail
Boom Cover. There is another level
mounted on the back of the seat frame