Filter
Top Products
RAIM not available - The GNC 300 is unable to cross-check its posi-
tion using RAIM. You may continue to navigate,
cross-checking your position every 15 minutes
using other navigation sources. If approach mode
is ACTV at the time of warning, navigation may
be continued for up to 5 minutes to complete the
approach procedure.
RAIM position warn - RAIM has detected position errors exceeding
those allowed for a given phase of flight. Revert to
an alternate source of navigation. If the warning
occurs during the final approach segment (FAF to
MAP), execute the published missed approach
procedure.
RAM failed - The GNC 300 has detected a failure in its inter-
nal memory. If the message persists, the GNC
300 is unusable and should be taken to an
authorized GARMIN service center.
Rcvr needs service - The GNC 300 has detected a condition requir-
ing service in the receiver hardware, and should
be taken to an authorized service center.
Ready for navigation - The GNC 300 is ready for navigation.
Received invalid wpt - A waypoint was received in an upload operation
that has an invalid identifier or position.
Receiver failed - The GNC 300 has detected a failure in the
receiver hardware. If the message persists, the
GNC 300 is unusable and should be taken to an
authorized GARMIN service center.
Remote ENT key stuck - The remote ENT key is stuck in the ‘pressed’
position. Check the installation.
Remote XFR key stuck - The remote XFR key is stuck in the ‘pressed’
position. Check the installation.
ROM failed - The GNC 300 has detected a failure in its per-
manent memory. If this message occurs, the unit
is unusable and should be taken to an autho-
rized GARMIN service center.
Route is empty - An attempt has been made to activate an empty
route.
Route is full - An attempt has been made to add more than 31
waypoints to a route. The GNC 300 will not
allow more than 31 waypoints per route.
Route truncated - The route was truncated because not enough
room existed to insert a SID, STAR or approach.
Route wpt deleted - One or more route waypoints were deleted while
receiving data from the optional PC Interface
Kit.
Route wpt locked - At least one route waypoint is locked because
the waypoint has been removed from the
Jeppesen NavData®, the data card is missing, or
the data card has failed.
113
Getting Started
Status & Position
SECTION
D
MESSAGES &
ABBREVIATIONS
300 7/14/98 8:51 AM Page 113