Filter
Top Products
3-32
Garmin G600 Pilot’s Guide
190-00601-02 Rev. B
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
GlossaryAppendix A
Appendix B
Index
3.3.3.3 Traffic Feature Options (Optional)
The Traffic group selection from the Map Setup Page Menu allows you to
customize the display of traffic on the Navigation Map. The Traffic function
requires the installation of the appropriate traffic device. TIS and TAS cannot be
displayed at the same time. If the aircraft has a TAS unit installed, the GDU 620
will be configured for TAS. If no TAS unit is installed and a GTX transponder is
installed then the GDU 620 will be configured for TAS. A pilot can tell which
data is being displayed by the label in the top left corner (TAS OPERATING vs
TIS OPERATING). TIS data comes from a GTX transponder. Coverage is limited
to specific areas as shown in the AIM. TAS data comes from a TAS unit such as a
Skywatch 497, KTA 810, or other unit. Coverage follows the airplane.
Traffic Selection Display Result
Off No traffic displayed
All Traffic All types of traffic displayed
TA/PA Traffic Alerts and Proximity Alerts displayed
TA Only Traffic Alerts Only displayed
Table 3-3 Navigation Map Traffic Display Options
Figure 3-42 Navigation Map Page Menu Traffic Group Selection
1) While viewing the Navigation Map Setup page and the Traffic Group active,
turn the large MFD knob to highlight the “Traffic” options.