Filter
Top Products
3-29190-00601-02 Rev. B
Garmin G600 Pilot’s Guide
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
NEXRAD Viewing Range
The NEXRAD Viewing Range option allows you to select the map range
where below that value NEXRAD weather products will be shown on the MFD.
When Off is selected, NEXRAD weather will not be shown. Map ranges above
the selected value will not show the NEXRAD weather products.
Topo data and NEXRAD may not be displayed at the same time. Turning on
either Topo data or NEXRAD will automatically turn off the other one. Turning
off either Topo data or NEXRAD will not automatically turn the other one back
on.
Figure 3-39 NEXRAD Viewing Range Selection
1) While viewing the Navigation Map Setup page and the Weather Group active,
turn the large MFD knob to highlight the “NEXRAD Viewing Range” option.
2) Turn the small MFD knob to change the highlighted value.
3) Press ENT
to accept the displayed value. The next option will be highlighted.
4) Press the small MFD knob to cancel selection or to end editing and return to
the Navigation Map page or turn the large MFD knob to the next option.