Filter
Top Products
1-20
Garmin G600 Pilot’s Guide
190-00601-02 Rev. B
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
GlossaryAppendix A
Appendix B
Index
•SelectedVerticalSpeed
•AirspeedBugValues
•AirspeedColorBandValues
•SystemPressureUnits
•SystemTemperatureUnits
The following information can be synchronized between GDU 620s, or
changed independently, depending on the Crossfill Synchronization Settings:
•BarometricCorrection(defaultON)
•SelectedCDI(defaultOFF)
When Barometric Correction is synchronized, any changes to the Barometric
Setting on either GDU will change it on both GDUs.
When the CDI is synchronized, any changes to the selected CDI on either
GDU will change it on both GDUs. Either pilot can change the OBS course on
either GNS. If the pilot selects GPS1 on the CDI and GNS1 is in OBS mode, any
course changes will move the OBS on GNS1, GDU1, and GDU2 (if the copilot
has GPS1 displayed on the CDI). Similarly, if the pilot selects GPS2 on the CDI
and GNS2 is in OBS mode, any course changes will move the OBS on GNS2,
GDU1, and GDU2 (if the copilot has GPS2 displayed on the CDI).
AHRS 1 and ADC 1 will only be displayed on GDU 1. AHRS2 and ADC2 will
only be displayed on GDU 2.
The CDI soft key toggles between selection of GPS or VOR/LOC as the active
navigation source. In a single GDU 620 system, the GDU CDI soft key will
change the source in the connected navigator and making a source change in the
navigator will be reflected in the GDU 620. In a dual GDU 620 system, the CDI
keys in the navigator are disabled.
1.3.5.2 Crossfill Selection
Crossfill for CDI and Baro Corrections must be selected in Aux mode in both
units.
1) While viewing the first page of the AUX page group, press the small MFD
knob and turn the large MFD knob to highlight “CDI” or “BARO” in the
“Synchronization” box.