Filter
Top Products
3-15190-00601-02 Rev. B
Garmin G600 Pilot’s Guide
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
Auto Zoom
With a valid flight plan, the Auto Zoom feature will automatically change
the Navigation Map range depending on the distance to the next waypoint in
the flight plan. If enabled, it will also automatically zoom to the SafeTaxi zoom
range when the aircraft transitions from “in air” to “on ground.” Auto Zoom can
be overridden at any time by manually zooming with the RNG keys or enabling
OBS mode. Auto Zoom is re-enabled once one of the following conditions is
met:
1) a waypoint is sequenced,
2) the aircraft transitions from “on ground” to “in air,”
3) a point is reached where the Auto Zoom range matches the manual
override range (known as auto-sync),
4) Auto Zoom is toggled of and back on in the Navigation Map Setup page,
Or
5) OBS mode is turned off.
1) While viewing the Navigation Map 1 or 2 of the Map page group, press the
MENU key. With “Map Setup” highlighted, press ENT. With the Map Group
active, turn the large MFD knob to highlight the “Auto Zoom” option.
2) Turn the small MFD knob to select On or Off.
Figure 3-17 Navigation Map Auto Zoom
3) Press ENT
to accept the displayed value. The next option will be highlighted.
4) Press the small MFD knob to cancel selection or to end editing and return to
the Navigation Map page or turn the large MFD knob to the next option.