Filter
Top Products
2-16
Garmin G600 Pilot’s Guide
190-00601-02 Rev. B
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
GlossaryAppendix A
Appendix B
Index
2.7.2 Changing CDI Course
The Selected Course is shown to the upper right of the HSI for 3 seconds
after being adjusted.
New Course Setting
Figure 2-25 Course Setting
1) Press the CRS key to activate Course mode.
2) Turn the PFD knob to change the Course values.
Or
3) Press the PFD knob to set a Course that will center the CDI to the VOR station
or waypoint if in GPS OBS mode.
2.7.3 Vertical Deviation Indicator (VDI)
The Vertical Deviation (Glideslope) Indicator (VDI) appears to the left of
the VSI whenever an ILS frequency is tuned in the active NAV field. A green
diamond acts as the VDI Indicator, like a glideslope needle on a conventional
indicator. If a localizer frequency is tuned and there is no glideslope signal, “NO
GS” is annunciated. The glideslope on an ILS approach is only shown if the
current heading is within 90° of the selected course. This prevents the glideslope
from being displayed during localizer backcourse approaches.
Vertical Deviation Source
Vertical Deviation Indicator
Figure 2-26 Vertical Deviation Indicator (ILS Source)
The vertical deviation is similar to the glideslope for GPS approaches
supporting WAAS vertical guidance (LNAV+V, L/VNAV, LPV) and is generated
by the system to reduce pilot workload during approach. When an approach of
this type is loaded into the flight plan and GPS is the selected navigation source,
the Vertical Deviation Indicator appears as a magenta diamond. If the approach