Filter
Top Products
Connecting Your Vista Cx to a
Computer
You can connect your Vista Cx to your computer
using the PC/USB connector cable.
NOTE: Fully install the supplied MapSource
Trip & Waypoint Manager software on your
computer before connecting the USB cable to the
computer. Follow the instructions for installation
and operation provided with the software.
To connect your Vista Cx to your
computer:
1. Lift the USB port protective cover from the
back of the Vista Cx, and insert the smaller
connector on the USB cable into the matching
port.
2. Connect the remaining cable end to your
computer's USB port.
Information about USB Drivers
The USB drivers are automatically installed when
you install the MapSource Trip and Waypoint
Manager software that came with your Vista Cx.
When you initially connect the Vista Cx to a USB
port, your computer might prompt you to locate the
destination of the drivers for the device. You only
need to install the drivers once. After the drivers are
installed, your computer always detects your Vista Cx
when it is connected. USB drivers might be updated
periodically. You can find updates at
www.garmin.com.
92 eTrex Vista Cx Owner’s Manual
APPENDIX > CONNECTING YOUR VISTA CX TO A COMPUTER