Filter
Top Products
CABLE ROUTING
2-36
4D3D
1. Clutch switch lead
2. Handlebar switch lead
3. Bolt
4. Hexagonal head bolt
5. Main harness
6. Air vent hose
7. Clamp
8. Battery negative lead
9. AC magneto lead
10.Carburetor overflow hose
11.Neutral switch lead
12.Starter motor lead
13.Ignition coil spark plug lead
14.Ignition coil
15.Drain hose
16.Frame complete
17.Damper plate
18.Seat pad
19.Rear brake light switch lead
20.Carburetor warmer lead
21.Side cover
22.Breather hose
23.Air filter joint
24.Air filter case
A. To the left headlight
B. To the front fender
C. Route the wire harness above the guide for
the damper plate.
D. Fix point for wire harness
E. Clamp near the hook of the air filter.
F. Clamp near the edge of the air filter case.
G. Route the drain hose in front of the left oil
cooler hose.
H. Clamp on top of the frame bracket.
I. Route the clamp through the damper plate
hole.
J. Route the carburetor overflow hose as
shown in the illustration.
K. Fasten the clamp with the engine.
L. Route the clamp through the frame
bracket.
M. Route the leads on the upper inside of the
side cover.
N. Place the couplers on the inside of the side
cover.