Filter
Top Products
REAR WHEEL
4-10
EAS22040
REMOVING THE REAR WHEELS
1. Stand the vehicle on a level surface.
WARNING
EWA13120
Securely support the vehicle so that there
is no danger of it falling over.
TIP
Place the vehicle on a suitable stand so that
the rear wheel is elevated.
2. Remove:
• Rear wheels
EAS29430
CHECKING THE REAR WHEELS
The following procedure applies to both of the
rear wheels.
1. Check:
•Tire
• Wheel
Refer to “CHECKING THE TIRES” on
page 3-29 and “CHECKING THE
WHEELS” on page 3-31.
2. Measure:
• Wheel runout
Refer to “CHECKING THE FRONT
WHEELS” on page 4-5.
Over the specified limit → Replace.
3. Check:
• Wheel balance
Refer to “ADJUSTING THE REAR
WHEEL STATIC BALANCE” on page 4-
10.
Out of balance → Adjust.
EAS29440
CHECKING THE REAR WHEEL HUBS
The following procedure applies to both of the
rear wheel hubs.
1. Check:
• Wheel hub “1”
Cracks/damage → Replace.
• Splines (wheel hub) “2”
Wear/damage → Replace.
EAS29450
INSTALLING THE REAR WHEEL HUBS
The following procedure applies to both of the
rear wheel hubs.
1. Install:
• Rear wheel hub
• Washer
•Rear axle nut
• Cotter pin
Refer to “INSTALLING THE FRONT
WHEEL HUBS” on page 4-6.
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
TIP
After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
1. Adjust:
• Rear wheel static balance
Refer to “ADJUSTING THE FRONT
WHEEL STATIC BALANCE” on page 4-7.
EAS29460
INSTALLING THE REAR WHEELS
The following procedure applies to both of the
rear wheels.
1. Install:
• Rear wheel
Refer to “INSTALLING THE FRONT
WHEELS” on page 4-8.
Radial wheel runout limit
2.0 mm (0.08 in)
Lateral wheel runout limit
2.0 mm (0.08 in)
Rear axle nut
120 Nm (12.0 m·kg, 89 ft·lb)
Rear wheel nut
45 Nm (4.5 m·kg, 33 ft·lb)
New