Filter
Top Products
CLUTCH
5-36
11.Adjust:
• Push lever position
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Loosen the locknut “1”.
b. Turn the adjusting screw “2” in or out until
the marks are aligned.
c. Hold the adjusting screw to prevent it from
moving and then tighten the locknut to
specification.
ECA13820
Do not overtighten the locknut since this
will remove the free play between both
push rods.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
12.Check:
• Clutch cable free play
Refer to “ADJUSTING THE CLUTCH
CABLE FREE PLAY” on page 3-12.
13.Install:
•Clamp
• Dowel pin
• Crankcase cover gasket
Locknut
8 Nm (0.8 m·kg, 5.9 ft·lb)
Clutch cable free play
5.0–10.0 mm (0.20–0.39 in)
New