Filter
Top Products
HANDLEBAR
4-40
EAS22860
REMOVING THE HANDLEBARS
1. Remove:
• Clutch switch “1”
TIP
Push the fastener when removing the clutch
switch out of the clutch lever holder.
2. Remove:
• Handlebar grip “1”
TIP
Blow compressed air between the left handle-
bar and the handlebar grip, and gradually push
the grip off the handlebar.
EAS22880
CHECKING THE HANDLEBAR
1. Check:
• Handlebar “1”
Bends/cracks/damage → Replace.
WARNING
EWA13690
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken it.
EAS22911
INSTALLING THE HANDLEBAR
1. Install:
• Handlebar
• Upper handlebar holders
TIP
• Install the handlebar horizontally shown in
the illustration.
• The upper handlebar holder should be
installed with the punched mark “1” forward
“2”.
ECA4D3F004
First, tighten the bolts “3” on the front side
of the handlebar holder, and then the bolts
“4” on the rear side.
2. Install:
• Handlebar grips “1”
Upper handlebar holder bolt
20 Nm (2.0 m·kg, 15 ft·lb)