Filter
Top Products
PICKUP COIL ROTOR AND STARTER CLUTCH
5-46
EAS403F009
REMOVING THE PICKUPCOIL ROTOR
1. Remove:
• Pickup coil rotor bolt “1”
• Washer
TIP
• Loosen the pickup coil rotor bolt “1” while
holding the rotor with a sheave holder “2”.
• Do not allow the sheave holder to touch the
projection on the rotor “a”.
2. Remove:
• Pickup coil rotor “1”
TIP
Remove the rotor using flywheel puller “2”.
3. Remove:
• Woodruff key “1”
4. Remove:
• Starter idle gear 2 “1”
• Starter wheel gear “2”
• Bearing “3”
• Washer “4”
EAS403F013
CHECKING THE STARTER CLUTCH
1. Check:
• Starter clutch rollers
Damage/wear → Replace the starter
clutch.
2. Check:
• Starter idle gear “1”
• Starter wheel gear “2”
• Starter clutch gear “3”
Burrs/chips/roughness/wear → Replace
the defective part(s).
Sheave holder
90890-01701
Primary clutch holder
YS-01880-A
Flywheel puller
90890-01362
Heavy duty puller
YU-33270-B
Bolt (M8 × 80 mm)
90890-01359