Filter
Top Products
CHAIN DRIVE
4-60
3. Bend the lock washer tab along a flat side
of the nut.
4. Install:
• Master link “1”
• O-ring “2”
• Master link plate “3”
ECA14300
Never install a new drive chain onto worn
drive chain sprockets; this will dramatically
shorten the drive chain’s life.
5. Install:
• Master link clip “1”
ECA4D3F007
The closed end of the master link clip mast
face in the direction of drive chain rotation.
6. Adjust:
• Drive chain slack
Refer to “ADJUSTING THE DRIVE
CHAIN SLACK” on page 3-21.
ECA13550
A drive chain that is too tight will overload
the engine and other vital parts, and one
that is too loose can skip and damage the
swingarm or cause an accident. Therefore,
keep the drive chain slack within the speci-
fied limits.
New
Drive chain slack
45–55 mm (1.77–2.17 in)