Filter
Top Products
Page 58
How Do I Use It?
3. The map appears with the selected point in the middle. Tap
(Simple mode) or
(Advanced mode) from the Cursor menu. The route is then
automatically calculated, and you can start navigating.
Selecting the destination from the POIs
You can select your destination from the POIs included with TRAX436 or
from the ones you have previously created.
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons:
(Simple mode), or
, (Advanced mode).
2. Select the area around which the POI should be searched:
•
: The POI will be searched around a given address.
•
: The map appears with the Cursor in the middle.
Modify the location of the Cursor if necessary, then tap
. The POI will be searched around the given
location.
•
: The POI will be searched around the current
GPS position.
•
: The POI will be searched around the
destination of the active route.
•
: The POI will be searched not around a given
point but by the size of the detour it means from the active
route. This can be useful if you search for a later stopover
that causes only a minimal detour. For example upcoming
petrol stations or restaurants.