Filter
Top Products
Page 51
How Do I Use It?
2. Enter the house number on the keyboard.
3. Tap
tonishenteringtheaddress.
6. A list appears with the matching addresses. Tap the desired
one.
7. The map appears with the selected point in the middle. Tap
(Simple mode) or
(Advanced mode) from the Cursor menu. The route is then
automatically calculated, and you can start navigating.
Entering an address without knowing the
district/suburb
Long roads can run across several districts or suburbs. You may not know
if a particular house number is in which of them. In this case, follow the
instructions below:
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons:
(Simple mode), or
, (Advanced mode).
2. By default, TRAX436 proposes the country/state and settlement
where you are. If needed, tap the button with the name of the
country/state, and select a different one from the list.
3. If needed, change the settlement:
• Toselectthesettlementfromthelistofrecentlyusedones,
tap the
button.
• Toenteranewsettlement:
1. Tap the button with the name of the settlement, or if you
have changed the country/state, tap
.
2. Start entering the settlement name on the keyboard.