Filter
Top Products
Copernicus GPS Receiver 235
NMEA 0183 C
RT - Reset
This sentence can be used to Set the reset type. No query is supported.
$PTNLaRT,b,c,d..x*hh<CR><LF>
Table C.28 Reset Type
Field Description
a Mode (S = set; R = Response)
b Command
C Cold software reset, Erase SRAM including the
customer configuration in SRAM and restarts.
W Warm software reset. Erases the ephemeris information
in SRAM and restarts.
H Hot software reset. Uses the entire SRAM data.
F Factory software reset. Erases the customer
configuration, the almanac, ephemeris and last
position in Flash Memory and in SRAM
S Set the receiver into Standby Mode.
c Flash operation
0reserved
1reserved
2 store user configuration to Flash Memory
3 store user configuration to Flash Memory
4 Erase Almanac, ephemeris and last position from Flash
Memory
5 Erase user configuration from Flash Memory
6 Erase Almanac, ephemeris, last position and user
configuration from Flash Memory
d Wakeup from Standby Mode flags:
001 Wakeup with serial Port A activity
010 Wakeup with serial Port B activity
011 Wakeup with serial Port A or B activity
100 Wakeup after elapsed time specified in the next
field
101 Wakeup after elapsed time specified in the next
field or serial Port A activity
110 Wakeup after elapsed time specified in the next
field or serial Port B activity
111 Wakeup after elapsed time specified in the next
field or serial Port A or B activity
x..x If command is 'S', this field specifies time to stay in Backup
(Standby) Mode in seconds. Maximum value 2
31
.