Filter
Top Products
Installation and Maintenance 13
USE ALL OF THE LIFT LUGS PROVIDED.
NEVER STACK THE PIPE CABINET AND INLET
HOODS ON THE UNIT AS THE UNIT IS BEING LIFTED.
2 Lift all sections individually using all lifting lugs
provided and shown in
Figure 4
. See specific
instructions for handling the inlet and exhaust
hoods and pipe chase in paragraphs following.
3 Remove all wooden blocks before installing the
unit to the roof curb (see
Figure 5
).
4 After the sections are in place, assemble them
(see Unit Assembly).
Lifting Inlet and Exhaust Hoods
CAUTION
Do not attach the hood to the unit
prior to lifting the unit. Doing so
could damage the equipment.
Follow all warnings lifting instructions in the general
Lifting section of this manual to include test lifting.
Lift the hood sections individually as shown in
Figure
2
. Attach the cables, chains or straps to lifting lugs
as shown.
Attach the hood to the unit only after all sections are
in place.
Figure 2
Inlet and Exhaust Hood Lifting
Lifting the External Pipe Cabinet (Chase)
CAUTION
Do not attach the pipe chase to the
unit prior to lifting the unit. Doing
so could damage the equipment.
Follow all warnings lifting instructions in the general
Lifting section of this manual to include test lifting.
Lift the pipe chase section individually as shown in
Figure 3
. Attach the cables, chains or straps to lifting
lugs as shown.
Attach the pipe chase to the unit only after all
sections are in place.
Figure 3
Pipe Cabinet Lifting
Recommended
to lift lugs
attachment
Rigging and spreader bar
not furnished by Trane
Recommended
attachment to
lifting lugs