Filter
Top Products
12 CLCH-IM-16A
Lifting Instructions
The Trane Company recommends that the contractor
use spreader bars and slings to rig units and
subassemblies (sections) as shown.
q Always assemble the unit at the installation site.
q Always rig subassemblies or sections as they ship
from the factory.
q Make the loop of the sling parallel to the direction
of airflow, whenever possible.
The following instructions cover lifting the unit as well
as inlet and exhaust hoods and external pipe chases.
Follow specific instructions.
WARNING
Follow good lifting practices
before lifting the unit to include
following instructions in this man-
ual, estimating center of gravity,
and test lifting the unit to check
balance and stability.
Do NOT use fork lifts for handling
units.
Never lift units in windy conditions
or raise units above personnel.
Failure to follow all instructions
may result in personal injury or
equipment damage.
1 Before lifting the unit, estimate the approximate
center of gravity and test lift the unit to determine
balance and stability.
NOTE: PREPARATION OF THE ROOF CURB OR PIER
MOUNT AND ROOF OPENINGS SHOULD BE
COMPLETED BEFORE LIFTING UNIT TO THE ROOF.
SEE THE ASSEMBLY SECTION OF THIS MANUAL.
2 873 932 778
4 1471 1643 1547 1516
6 2068 2355 2219 2275 2114
8 2664 3066 2893 2872 2710
10 3262 3777 3565 3632 3307
12 3859 4490 4268 4228 3904
Table 21
Unit Size 100, Approximate Dry Coil Weights, Fin Series 168 (Weights in lb)
Coil Type
Rows W K P2 P4 P8 D DD WD WA WC NS
1 729 N/A N/A N/A 546 603 909
2 1065 1131 945
4 1815 2010 1900 1866
6 2565 2889 2733 2802 2613
8 3315 3771 3570 3552 3363
10 4062 4653 4404 4488 4113
12 4812 5529 5238 5238 4863
Table 20
Unit Size 80, Approximate Dry Coil Weights, Fin Series 168 (Weights in lb)
Coil Type
Rows W K P2 P4 P8 D DD WD WA WC NS