Filter
Top Products
A-17
Utilities and Diagnostic Tests
MU Sleep Mode
If you set MU Sleep Mode On, the radio stays powered on when the rest of the terminal
powers down because of inactivity. You can wake the terminal by sending a message directly
to it, but broadcast messages will not wake it. If you set the switch Off, the radio powers off
if the rest of the terminal powers down because of inactivity. The default setting is On. To
configure MU Sleep Mode:
1. Select
MU Sleep Mode
to display the screen shown in Figure A-19.
2. Use the UP or DOWN arrow keys to select On or Off.
3. Press CLEAR or ENTER to return to the main menu.
Figure A-19. Setting Sleep Mode
Boot Mode
This option determines what network communication parameters the terminal will use when
it boots. To configure Boot Mode:
1. Select Boot Mode to display the screen shown in Figure A-20.
2. Use the UP or DOWN arrow keys to select
Boot
,
DHCP
, or
Manual Entry
options.
3. Press CLEAR or ENTER to return to the main menu.
Figure A-20. Setting Boot Mode
MU SLEEP MODE
Radio State:
On
BkSp, CLR, Enter
BOOT MODE
Get IP from:
Manual Entry
BkSp, CLR, Enter