Filter
Top Products
A-6
VRC 6940 Product Reference Guide
Note: DIAG24 uses a message file (msg.msg) that it reads from the same
drive and directory as the DIAG24 software. If you see corrupted
screens, the message file may be missing.
4. Select a Roaming Mode. If you want the terminal to ping an AP, but roam between
APs as you move around, select Roaming Enabled. If you want to ping a specific
AP, select that AP identifier from the list. If more APs are in range than can fit on one
screen, then the last selection will be More. Selecting this will present more available
APs for selection.
Figure A-4 shows a Roaming Enabled option, followed by a list of AP identifiers. For
each AP identifier, bb represents the AP identifier (or BSS identifier) and
eeeeeeeeeeee represents the 48-bit MAC address of the AP in hexadecimal
notation.
Figure A-4. Selecting a Roaming Mode
5. Press 1, 2 or 3 to select the ping message size:
Figure A-5. Selecting Ping Message Size
<Test Mode>
1. Roaming Enabled
2. bb--eeeeeeeeeeee
3. bb--eeeeeeeeeeee
4. bb--eeeeeeeeeeee
....
n. bb--eeeeeeeeeeee
Select[1-n or 'Q']:
<Test Mode>
MESSAGE SIZE
1. 100 bytes
2. 256 bytes
3. 512 bytes
Select[1-3 or 'Q']: