Filter
Top Products
5-7
Operating a VRC 6940
Bar Code Scanning
Attaching an External Bar Code Scanner
1. Press the ON/OFF key to suspend the terminal.
2. Remove the plug cover from the scanner port on the back of the terminal, shown in
Figure 5-4.
3. Fit the scanner’s connector plug into the connector. Align the red dot on the end of
the scanner cable with the red dot on the terminal’s scanner connector.
4. Press the ON/OFF key to power the terminal on.
Figure 5-4. Scanner Port
Using a Bar Code Scanner
For information on using a bar code scanner, consult the documentation that came with the
scanner.
Scanner Port
Back of Terminal